How to fit window tint

How to install window tinting film? How do you get the tint out of a window? You’ll need your tint kit ready at hand. The high quality window tint used by Miles of Motion is not only easier to fit, as it is less likely to rip during fitment, but also provides a longer lasting more professional finish.

With the help of your assistant, carefully place the adhesive side of the film over the window, starting at the bottom edge. While working upwards avoid crinkles, as many bubbles as you can, and pressing too har since the adhesive is sensitive to pressure.

WINDOW PREPARATION. Make up the slip solution in spray bottle (tsp washing up liquid to pint cold water ). Adhesive surface is protected between ‘window film’ and liner. FILM APPLICATION. Thoroughly wet the glass with the. Window film may be cut to. Start at the top of the tinting film and peel away the backing film, only peel it as far as half way down before spraying the now exposed adhesive side with tint solution.

Position the top, peeled section, against the window. Leave a gap of 3mm to the top edge of the window so the tint doesn’t catch and peel away again when the window is closed. Cutting and Measuring Your Tint 1. Spray the outside of the window with soapy water. The water will help the tinting temporarily adhere, but still make.

Place the tinting over the outside of the window so that it covers the entire window. Unroll your tinting so that it. Allow the adhesive enough time to stick to the window. Remove the application tape after a couple of hours, to hours should be enough.

If, when removing the application tape, you lift the window film from the window glass. Fill a spray bottle with water and add a couple of drops of baby shampoo. This mixture helps the film stick to the window but still lets you slide the film around so you can fit it properly into the corners before the mixture dries.

You have to be able to work fairly fast in order to properly apply the window tint. Remove the backing from the window tint and place it on the window you are planning on tinting. On curved glass, squeegee from the center to the bottom, then squeegee film toward the sides. Press firmly on squeegee to remove ALL.

More and more top-of-the-range cars are being fitted with tinted windows as. Step 3: Apply the Cut Tint to Your. If you choose to install your window film yourself, we have created a number of instructional videos that show the exact steps you will need to take to achieve a perfect application. The windscreen film must let in a minimum of 75% light.

The front side windows must let in a minimum of 70% light. Before you decide to add window tint film to your car, you need to be aware of the laws on tinted windows, as outlined by the Driver Vehicle Standards Agency (DVSA). Run the squeegee along the top of the window, pushing any air and water out of the top. You peel this away to reveal a sticky surface and this is how it is stuck to the window.

You spray soapy water onto the window and the sticky side of the film so that you can easily position the film correctly on the window. Does window tint stick to the inside or outside? This ensures that the window tint templates are an exact fit to your make and model.

Each of our kits comes with a step-by-step fitting guide, so you can easily do it yourself. However, if you do need extra help, we have free expert advice for you and equip each kit with a little additional high performance film, so you can practice.